Wet/Dry Vac Assembly/Disassembly; Back View - RIDGID MOB16000 Manual Del Usuario

SP7012 Ridgid MOB16000 ESF.qxp_SP7012 12/20/16 3:33 PM Page 9

Wet/Dry vac assembly/Disassembly

Disassembly
1. Remove the drum from the power
base by first sliding the drum lock from
the right to the left. This lock is located
on the front of the unit just above the
power switch, between the grey
portion of the drum and the power
base.
2. Lift up on the drum, using the lift
handle found on the lid of the drum.
Allowing the front of the drum to
come up first will cause the drum to
smoothly and properly disengage
from the power base.
3. With the drum sitting on the ground,
pull up on the lid latch handles found
on the left and right side of the drum.
Rotate the latches away from the lid.
4. Remove the lid from the drum
assembly and place it in a safe
location.
note: The filter has remained in the drum
and will remain there throughout the
emptying process keeping the collected
debris confined to the drum.
Drum
Drum
Lock
Power
Base
Lift Handle
Lid
Drum
ROTATE
BOTTOM
OF DRUM
FORWARD
Power Base
Drum Bottom
Rim

BACK VIEW

Lid Latch Hook
Latch (2)
9
Drum
SLIDE
TO UNLOCK
ROTATE DRUM
RIM FROM
UNDERNEATH
HOOK TO
UNLOCK
Power Base
Hook
Lid
ROTATE
LATCHES AWAY
FROM LID TO
UNLOCK