Wet/Dry Vac Assembly - RIDGID 1620RV0 Manual Del Usuario

SP6953 Ridgid 1620RV0_SP6542.qxd 1/16/15 10:00 AM Page 7
Accessory Storage (continued)
Cord Wrap
When vacuuming is complete, unplug the
cord and wrap it around the detachable
blower as shown.

Wet/Dry Vac Assembly

1. Locate the lid assembly and the drum
assembly (assembled earlier).
2. Position the lid assembly with the
detachable blower handle of the unit
located above the vacuum inlet on the
dust drum.
3. To assemble the lid assembly to the
drum assembly, lower the lid assembly
onto the dust drum. Rotate both
latches down until you hear them snap
over the drum latch catches of the
drum.
Detachable
Blower
Handle
Vacuum
Inlet
Drain Cap
7
Detachable
Blower
Cord
Wrap
Power
Cord
Cord Swivel
Lid Assembly with
Detachable Blower
Drum Latch
Drum Catch
Inlet
Dust Drum
Assembly