vitapur VWD2266W Manual D Uso Y Cuidado página 4

OPERATING INSTRUCTIONS
Initial Product Cleaning Procedure
Like most appliances, your water dispenser requires periodic maintenance for maximum
efficiency and performance and must be cleaned on a regular basis (i.e. every 4 months). To
maintain a hygienic environment within your water dispenser and prevent potential formation
(growth) of bacteria, we strongly recommend regular cleaning. A cleaning kit is available
through our Customer Service Department at 1-866-253-0447 or can be ordered on line
at www.greenwayhp.com.
1.
Make sure the unit is unplugged and the heating
power switch is "off".
2.
Remove the bottle support collar, saturate a clean
cloth with a water dispenser cleaner or vinegar
and wipe the inside of the reservoir.
3.
Pour the water dispenser cleaner or a mixture of
4 cups / 1 L of vinegar with 4 cups / 1 L of hot
water into the reservoir and wait 20 minutes.
IMPORTANT:
To avoid water overflow while cleaning the dispenser, always remove the bottle
support collar before pouring water or cleaning solution into the reservoir (see Figure A).
4.
Press both dispensing taps until water no longer comes out.
5.
Using a bucket, drain the reservoirs from the drain valve on the
back of the unit.
6.
Rinse again with clean water, re-install drain valve plug and cover.
7.
Place bottle support collar back on top of dispenser.
Installing the Water Bottle
IMPORTANT:
Always wash your hands first! Clean the top (neck) of the bottle with a clean
cloth and do not touch the part of the unit that the water touches. Make sure the unit is
unplugged. The water bottle can be purchased from your local retailer.
1.
Remove the protective cap from the end of the water bottle unless the bottle has a
puncturable cap or sticker.
2.
Lift and turn the bottle upside down, placing it securely on the bottle support collar.
3.
Press and hold both dispenser buttons until water flows from the dispenser. Drain about
4 cups / 1 L of water before initial use. This does not need to be repeated with
replacement bottles.
4.
Plug in the water dispenser and switch on the hot water power switch (rear of dispenser).
ANti-leak bottle support collar
The bottle support collar on your water dispenser is engineered with a special anti-leak-proof
system to prevent accidental loss of water, (flooding) as a result of inadvertently installing a
defective water bottle. Unfortunately, not all water bottles are created equal. Almost all 3 and 5
gallon (12 &19L) water bottles are recycled and handled extensively during cleaning, filling, and
shipping. As a result, they are very prone to developing hairline fractures and pinhole leaks that
are not always obvious to the end user until the time of installation.
IMPORTANT: Never knowingly install a defective water bottle on a water dispenser. Return
immediately for replacement.
Figure A