Transportation & Installation - Toshiba TOSVERT VF-S15 Serie Manual De Inicio Rápido

EN
■ Handling
Disassembly
prohibited
Prohibited
Mandatory
action
■ Handling
Contact
prohibited
Mandatory
action
■ Transportation & installation
Prohibited
Mandatory
action
■ Transportation & installation
Prohibited
•
Never disassemble, modify or repair. This can result in electric shock, fire and injury.
Call your Toshiba distributor for repairs.
•
Never remove the terminal block cover when power is on. The unit contains many high
voltage parts and contact with them will result in electric shock.
•
Do not stick your fingers into openings such as cable wiring holes and cooling fan
covers. This can result in electric shock or other injury.
•
Do not place or insert any kind of object (electrical wire cuttings, rods, wires etc.) into
the inverter. This can result in electric shock or fire.
•
Do not allow water or any other fluid to come in contact with the inverter. This can
result in electric shock or fire.
•
Turn the power on only after attaching the terminal block cover. If the power is turned
on without the terminal block cover attached, this can result in electric shock or other
injury.
•
If the inverter begins to emit smoke or an unusual odor, or unusual sounds,
immediately turn the power off. Continuous use of the inverter in such a state may
cause fire. Call your Toshiba distributor for repairs.
•
Always turn the power off if the inverter is not used for long periods of time since there
is a possibility of malfunction caused by leaks, dust and other material. If power is left
on with the inverter in that state, it may result in fire.
•
Do not touch heat radiating fins or discharge resistors. These devices are hot, and
you'll get burned if you touch them.
•
Use an inverter that conforms to the specifications of power supply and three-phase
induction motor being used. If the inverter being used does not conform to those
specifications, not only will the three-phase induction motor not rotate correctly, but it
may also cause serious accidents through overheating and fire.
•
Do not install or operate the inverter if it is damaged or any component is missing.
This can result in electric shock or fire. Call your Toshiba distributor for repairs.
•
Do not place any inflammable objects near the inverter.
If an accident occurs in which flame is emitted, this could lead to fire.
•
Do not install in any location where the inverter could come into contact with water or
other fluids. This can result in electric shock or fire.
•
Operate under the environmental conditions prescribed in the instruction manual.
Operations under any other conditions may result in malfunction.
•
Mount the inverter on a metal plate. The rear panel gets very hot. Do not install in an
inflammable object, this can result in fire.
•
Do not operate with the terminal block cover removed. This can result in electric
shock. Failure to do so can lead to risk of electric shock and can result in death or
serious injury.
•
An emergency stop device must be installed that fits with system specifications (e.g.
shut off input power then engage mechanical brake). Operation cannot be stopped
immediately by the inverter alone, thus resulting in an accident or injury.
•
All options used must be those specified by Toshiba.
The use of any other option may result in an accident.
•
When using switchgear for the inverter, it must be installed in a cabinet.
Failure to do so can lead to risk of electric shock.
•
When transporting or carrying, do not hold by the front panel covers.
The covers may come off and the unit will drop, resulting in injury.
•
Do not install in any area where the unit would be subject to large amounts of
vibration. This could cause the unit to fall, resulting in bodily injury.
Warning
Caution
Warning
Caution
2
E6581929