Publicidad
Idiomas disponibles
Idiomas disponibles
From the ASWC-1 pre-wired harness with AUX jacks
(a) 12-pin harness to the aftermarket radio:
• This harness is to be used in conjunction with the optional ASWC-1
(not included) to retain steering wheel controls. If the ASWC-1 is not
being used, disregard this harness. If it will be used, please refer to the
ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• This harness will work with either early or late generation Toyota SWC
harnesses. Earlier generations use the 20-pin harness; later generations
use the 28-pin harness. Use the appropriate harness for your vehicle
(only one of the harnesses will connect into the vehicle). The 12-pin
harness will connect into the ASWC-1.
• Connect the Black wire to the ground wire.
(b) 20-pin or 28-pin harness to the aftermarket radio:
• Connect the Red RCA jack to the right audio AUX-IN.
• Connect the White RCA jack to the left audio AUX-IN.
INSTALLING THE BX-TY1
• Connect the 12-pin harness into the interface.
• With the key in the off position, connect the 20-pin harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Note: If using the ASWC-1, connect it after you initialize and test the
BX-TY1, with the key in the off position.
Axxess Integrate
axxessinterfaces.com
BX-TY1
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, then back on again.
IMPORTANT
If you are having difficulties with the installation of this product, please
call our Tech Support line at 1-800-253-TECH. Before doing so, look
over the instructions a second time, and make sure the installation was
performed exactly as the instructions are stated. Please have the vehicle
apart and ready to perform troubleshooting steps before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
•
metraonline.com
INITIALIZING THE BX-TY1
P
OWER
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
Publicidad
