Axxess BX-TY1 Manual De Instrucciones

BX-TY1
Lexus/Toyota digital amplifier interface
2001-up
• Retains factory AUX jack
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• USB updatable
INTERFACE COMPONENTS
• BX-TY1 interface • BX-TY1 harness
• ASWC-1 pre-wired harness with AUX jacks
APPLICATIONS
LEXUS
Avalon
(Camry) Solara
ES Series 2007-2012
Camry (w/o nav)
ES Series
Camry
(w/ multi disc) 2002-2006
Corolla
GS Series 2001-2005
FJ Cruiser
IS Series 2002-2005
Highlander
LS Series 2001-2006
Matrix
RX Series 2004-2008
Prius 3rd Gen
SC Series 2002-2010
(w/o nav)
Plug-In (PHV)
TOYOTA
(w/o nav)
4-Runner 2003-2013
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
Axxess Integrate
Installation Instructions for BX-TY1
FEATURES
2005-2012 Prius
2004-2008 Rav-4
2012-2013
Sequoia (w/o nav)
2007-2011
Sequoia
2003-2011
Sienna
2011-2014
Tacoma
2008-2013
Tundra
2005-2012
Tundra (Double Cab) 2004-2005
Venza (w/ SD card
2012-2015
based nav)
Venza
2012-2015
Yaris
axxessinterfaces.com
CAUTION!
Metra recommends disconnecting the negative battery terminal before beginning any installa-
tion, unless the vehicle manufacturer recommends against so. Please check with your local Dealership for
more information. All accessories, switches, climate controls panels, and especially air bag indicator lights
must be connected before reconnecting the battery or cycling the ignition. Also, do not remove the factory
radio with the key in the on position, or the vehicle running. It would be best to remove the key from the
ignition and then wait a few seconds before removing the factory radio.
From the BX-TY1 harness
(a) 20-pin harness to the aftermarket radio:
• Connect the Black and Black/White wire to the ground wire.
Note: If installing the ASWC-1, there will be a ground wire on the 12-pin
harness to connect as well.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
Note: If installing the ASWC-1, there will be an accessory wire on the 12-pin
harness to connect as well.
2004-2011
2004-2014.5
• Connect the Blue wire to the antenna turn-on wire.
2013
• Connect the Orange wire to the illumination wire (if applicable).
2005-2012
2004-2014
• Connect the White wire to the left front positive speaker output.
2005-2013
• Connect the White/Black wire to the left front negative speaker output.
2006-2013
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
2013-2014
2009-2012
(b) 12-pin harness to the aftermarket radio:
2007-2011
• Connect the Blue/White wire to the amp turn-on wire.
Note: This wire must be connected to hear sound from the factory amplifier.
•
metraonline.com
CONNECTIONS TO BE MADE
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
(continued on next page)