Metra 99-8232B Instrucciones De Instalación página 4

Installation instructions for 99-8232B
Double DIN radio provision
1. Remove the factory panel clips and attach
to the Metra radio trim panel in the same
order. This kit comes with six panel clips that
will only work with the upper six locations
around the vents. The two lower clips must
be factory.
2. Mount the climate control to the factory
brackets with the factory hardware.
(Figure A)
3. Mount the double DIN aftermarket radio to
the climate control/brackets assembly using
the screws supplied with the head unit.
(Figure A)
4. Locate the factory wiring harness in the
dash. Metra recommends using the proper
mating adapter from Metra or AXXESS.
Re-connect the negative battery terminal
and test the unit for proper operation.
METRA. The World's best kits.
Kit Assembly
5. Mount the radio/climate control assembly
into the dash.
6. Reassemble dash in reverse order of
disassembly using the 99-8232B
radio trim panel.
(Figure A)
® metraonline.com
K P
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION