Kit Assembly - Metra 99-8232B Instrucciones De Instalación

Dash Disassembly
8. Remove (1) Phillips screw from
each side of the pocket below the
radio/climate control assembly.
(2 screws total) (Figure G)
9. Unclip and remove the pocket.
(Figure G)
10. Remove (2) 10 mm bolts above
the radio (behind the a/c vents)
and (2) 10 mm bolts from behind
the climate control then unplug
and remove the assembly.
(Figure H)
11. Remove (10) Phillips screws
securing the brackets to the
radio/climate control assembly
and separate the radio from
the climate controls. (Retain
the factory panel clips, climate
controls, brackets and screws for
use during kit assembly).
Continue to kit assembly
(Figure G)
(Figure H)
99-8232B
ISO DIN radio provision with pocket
1. Remove the factory panel clips
and attach to the Metra radio trim
panel in the same order. This kit
comes with six panel clips that
will only work with the upper six
locations around the vents. The
two lower clips must be factory.
2. Mount the climate control to the
factory brackets with the factory
hardware. (Figure A)
3. Mount the pocket to the climate
control/bracket assembly with
the (4) #8 x 3/8" Phillips screws
supplied. (Figure A)
4. Slide the aftermarket radio into the
bracket assembly and secure with
screws supplied with the radio.
(Figure A)
5. Locate the factory wiring harness
in the dash. Metra recommends
using the proper mating adapter
3

Kit Assembly

from Metra or AXXESS. Re-connect
the negative battery terminal and
test the unit for proper operation.
6. Mount the radio/pocket/climate
control assembly into the dash.
7. Reassemble dash in reverse order
of disassembly using the
99-8232B radio trim panel.
Continued on back page
(Figure A)