Publicidad
Step 7
Fasten the OUTER LEFT END (B) to the LEFT MOLDING (S).
å
Tighten two TWIST-LOCK® FASTENERS.
S u r
T W
F A S
Page 12
B
i t h
e w
®
K
f a c
L O C
I S T -
E R S
T E N
How to use the SAUDER TWIST-LOCK® FASTENER
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
S
Dowel end
416514
O
www.sauder.com/services
Publicidad
