Publicidad
Step 2
Fasten four HALF DISKS (U) to four PLINTHS (T). Use four SILVER
å
1-1/8" FLAT HEAD SCREWS (10S).
Fasten ten ANGLE BRACKETS (27G) to the OUTER ENDS (A and B).
å
Use ten BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the edges of the ANGLE BRACKETS are even with
å
the edges of the ENDS.
Fasten the PLINTHS (T) and VERTICAL MOLDINGS (M35) to the
å
ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S).
The larger
hole should
be facing up.
T
27G
T
M35
The VERTICAL
MOLDINGS should
be centered over
the HALF DISKS.
www.sauder.com/services
U
U
T
U
T
T
Use the lower two
holes in the PLINTH.
U
(10 used)
B
Use the holes below the groove in
the VERTICAL MOLDING (M35).
416514
SILVER 1-1/8" FLAT HEAD SCREW
(4 used for the HALF DISKS)
The VERTICAL MOLDINGS should
be centered over the HALF DISKS.
27G
T
M35
A
BLACK 9/16" LARGE HEAD SCREW
(20 used for the ANGLE BRACKETS)
10S
Use the holes
below the groove
in the VERTICAL
MOLDING (M35).
1S
Page 7
Publicidad
