Installation Steps; Care And Cleaning - LUND AVS Bugflector Instrucciones De Instalación

Installation Steps

Expose 2" (5 cm) of tape liner from each end
of the flanges on the hood shield.
3
Remove remainder of tape liners. Apply strong
pressure at all contact points for proper adhesion.
5
Close hood.
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Center part on front edge of hood. If necessary
slide flanges under rubber trim.
4
Secure with (4) self tapping screws through
hood shield into sheet metal. NOTE: Toyota
Camry and Pontiac Sunfire have only (2)
6
NOTE: DO NOT OVER TIGHTEN
Apply bump ons to surface of hood.
8
8
7
Lund International
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
screw mounting locations.
Bump-on
hood
washer
screw
hood shield
rubber trim
(if equipped)