Publicidad
Idiomas disponibles
Idiomas disponibles
Application
Pot fillers are designed for delivering cold water from a
main supply. Pot fillers can be positioned above sinks
or stoves and the articulated nature of the spout
enables the outlet to be conveniently positioned above
pots / pans as required.
Specifications
• Min. flow rate
• Flow pressure
- min.
- recommended
- greater than 72.5 psi, fit pressure reducing valve
• Max. operating pressure
• Test pressure
Installation
Note:
When installing e. g. on plasterboard walls (not solid
walls) it must be assured that an appropriate rein-
forcement is in place to ensure sufficient strength.
Flush pipes thoroughly!
Mount pot filler
Refer to the dimensional drawing on fold-out page I.
1. Screw on nipple (A) by using an 10mm allen wrench,
see fold-out page II, fig. [1].
2. Push on flange (B) and level with spirit level, see
fig. [2].
3. Layout holes for fastening.
4. Drill holes and insert plugs (C), see fig. [3].
5. Fasten flange (B) and seal (D) to the wall by using
the screws (E), see fig. [4].
6. Screw in screw (B1) by using an 3mm allen wrench
to fasten flange (B) to nipple (A).
7. Push on pot filler and fix with the two set screws (F)
by using an 3mm allen wrench, see fig. [5].
Open water supply and check connections for
leakage!
1
15 L/min or 4 gpm / 20 psi
7.25 psi
14.5 - 72.5 psi
145 psi
232 psi
English
Operation
For ease of use the pot filler is fitted with two head-
parts.
If the pot filler is to be left unattended ensure both
ceramic cartridges are left in the closed position.
IMPORTANT:
NOT FOR USE AS A FIRE EXTINGUISHER!
Maintenance
Inspect and clean all parts, replace as necessary and
grease with special grease.
Shut off water supply!
I. Replacing the ceramic cartridges, see fig. [6].
1a. Loosen set screw (G1) by using an 2mm allen
wrench and pull off lever (G).
1b. Unscrew screw (H).
2a. Remove shut-off knob (J) and pull off snap
insert (J1).
2b. Pull off sleeve (K).
3.
Unscrew ceramic cartridge (L) by using a 17mm
socket wrench and remove O-ring (M).
4.
Change either complete ceramic cartridge (L) or
O-ring (L1) and reinstall O-ring (M).
II. Flow control, see fold-out page I.
Unscrew and clean flow control (13 922).
Assemble in reverse order.
Observe the correct installation position!
Replacement parts, see fold-out page I ( * = special
accessories).
Care
Instructions for care of this faucet will be found in the
Limited Warranty supplement.
Publicidad
