Configuring Flareconair; Selecting A Channel; Selecting A Signal Input Mode - Chauvet FlareCON Air Guía De Referencia Rápida

FlareCON Air QRG
Configuring
FlareCONAir

Selecting A Channel

Selecting A Signal
Input Mode
www.liveline.be
Configuring FlareCON Air involves selecting the operating channel and input
mode—either Wi-Fi™ to operate it from a mobile device, or DMX to connect it
to a controller.
The Wi-Fi™ channel can be selected manually or automatically. Manual selection
is more reliable in areas that may be affected by wireless interference.
To manually select an operating channel, do the following:
1. Connect FlareCON Air to power. The red light should be on and the display
should be lit.
2. Press <MENU> until Manual Channel shows in the display.
3. Press <ENTER>. The current channel number becomes highlighted.
4. Use <UP> or <DOWN> to scroll through channel numbers <CH01> to
<CH16>.
5. Press <ENTER> to select the channel number. Use this same channel to set
the other products' receiving channel.
Chauvet recommends using the Manual Channel option for selecting the
FlareCON Air channel.
To automatically select an operating channel, do the following:
1. Connect FlareCON Air to power. The red light should be on and the display
should be lit.
2. Press <MENU> until Auto Channel shows in the display.
3. Press <ENTER>. The current channel number becomes highlighted.
4. Press <AUTO>. The display will flash, and stop. The signal indicator light
will flash, and then stop when it selects a channel.
The channel number shown when the display stops is the Wi-Fi™ channel
selected by the FlareCON Air. Use this same channel to set the other products'
receiving channel.
Selecting the signal mode input determines how the FlareCON Air receives
control signals, either in Wi-Fi™ mode from the FlareCON app or in DMX mode
from a DMX controller or another light.
To set the signal input mode, do the following:
1. Connect the FlareCON Air to power. The red light should be on and the
display should be lit.
2. Press <MENU> until Input Mode shows in the display.
3. Press <ENTER>. The current input mode becomes highlighted.
4. Use <UP> or <DOWN> to select the <WIFI> or <DMX > mode.
5. Press <ENTER> to set the desired input mode.
9
EN