Operating The Heating Pad; Cleaning And Maintenance - Lanaform Heating Blanket S1 Manual Del Usuario

or its after-sales department.
• This device should not be used by young children, people who are insensitive to heat or on animals.
• The device should not be used on a folding bed or on a bed, a section of which can be adjusted.
• Examine the device frequently to check for any signs of damage to the product or signs of wear. If you notice signs of
wear or damage, stop using this product immediately and take it back to the supplier or the its after-sales department.
USING THE HEATING PAD
Diagram and description:
1) OFF button
2) Position "1" (1st setting)
3) Position "2" (2nd setting)
4) Position "3" (3rd setting)
5) Display screen

Operating the heating pad:

• Put the pad down flat on the bed. The light side of the heating pad should be against the
mattress. The end of the pad without the controller should be placed at the foot of the
bed.
• Only put a sheet or fine cotton mattress over the pad so that you can feel the heat.
• Connect the plug to the socket on the side of the pad and the other end to an electricity
supply (AC220-240V). Make sure that there is a power socket nearby and that the power
cable is not in a position where the user may trip over it.
• To pre-heat the pad, select the third setting for 15 minutes. The temperature will
gradually rise.
• After pre-heating, get on to your heating pad and turn the control button to the heat
setting you require. If you use the pad for a long time or if you're going to sleep, select the
first setting. It will take about 15 minutes for the pad to reach the required temperature.
• To turn the device off, turn the button to the "Off" position.
Note: The heating pad is set to run continuously for three hours. If you wish to extend that time, it is advisa-
ble to let the heating pad cool down first for 5 minutes before using it again.
The photographs and other images of the product in this manual and on the packaging are as accurate as possible, but
do not claim to be a perfect reproduction of the product.

CLEANING AND MAINTENANCE

When you are not using the heating pad and before cleaning it, follow the instructions below:
- Make sure the control button is in the "OFF» position.
- Disconnect the power supply.
- Disconnect the plug linking the control to the device.
- Leave the pad to cool before cleaning.
CLEANING
Small stains can be cleaned with a cloth or a damp sponge and, if necessary, with a little liquid detergent for delicate
fabrics.
Warning: the electric heating pad should not be dry-cleaned, bent, dried in a dryer or machine-pressed or ironed.
If the pad is very dirty, it can be washed in a washing machine. Set it to the 30°C programme for delicate fabrics. Use a
detergent for delicate fabrics and measure it out according to the manufacturer's instructions.
Do not wash the pad too often to avoid excessive wear and tear. The pad should not be washed in the washing machine
more than 5 times during its life.
5
4
3
2
1
Heating Blanket S1
EN
3