Understanding The Remote Transmitter - Radio Systems PetSafe HDT11-11049 Guía Para El Uso Y El Amaestramiento

THE PREVIOUS LEVEL AND REPEAT THE PROCESS.
6. If your pet continues to show no response at Level 10, check the fi t of the Receiver Collar. If your pet has
long or thick hair, replace the Contact Points with the longer set. Then go back to # 2 and repeat the process.
If this still does not yield any results, your pet's hair will need to be trimmed around the Contact Points.
If all of these steps have been done and your pet continues to show no reaction to the stimulation, contact the
Customer Care Center at 1-800-732-2677.
_____________________________________________________________________________

Understanding the Remote Transmitter

To train using the Tone Only Button:
The audible sound emitted by the Receiver Collar can be just as effective as the stimulation for some dogs. The
Transmitter Indicator Light will glow for as long as this button is pressed. To use this button for training, simply
substitute "Tone Only Button" whenever "Stimulation Only Button" is used in the Training Guide section.
To train using the Stimulation Only Button:
You control the timing of the stimulation being applied to your pet. The stimulation stays on as long as the
Stimulation Only Button is pressed. If this button is pressed longer than 8 seconds, the Remote Transmitter will
"time-out," the Transmitter Indicator Light will turn off, and stimulation will no longer be delivered to your pet.
This is a safety feature in the Remote Transmitter. If the Remote Transmitter times out, release the Stimulation
Only Button and press it again to deliver stimulation.
Note: For either one or both of these training methods to be effective, they must be used consistently along with the
command you are trying to teach your pet.
10 1-800-732-2677