Radio Systems PetSafe HDT11-11049 Guía Para El Uso Y El Amaestramiento página 7

4. Install two (2), 3-volt batteries positive (+) side up (2C, 2E).
5. Slide the Battery Lid into the Receiver Collar.
6. Reinstall the screws (2C, 2F). Do not over-tighten the screws.
Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the Customer Care
Center or visit our website at www.petsafe.net for a list of common retailers.
2A
2
3
2D (HDT11-11048)
Receiver Collar
Turning the Receiver Collar On and Off
To turn the Receiver Collar on, press and release the On/Off Button. The Receiver Indicator Light
will fl ash twice after the button is released, indicating the Receiver Collar is ready to receive signals
from the Remote Transmitter.
Once the Receiver Collar has been turned on, press the top button of the Remote Transmitter. Upon
pressing, the Receiver Collar should beep for as long as the top button is pressed. If it does not, see
"To Pair the Remote Transmitter and the Receiver Collar" in the Troubleshooting section.
To turn the Receiver Collar off, press and release the On/Off Button. The Receiver Indicator Light
will fl ash three times after the button is released, indicating the unit has been turned off.
Note: To extend the life of the batteries, turn the Receiver Collar off when it is not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery life (before
replacing batteries) will be two weeks.
2B (HDT11-11049)
2
3
2E (HDT11-11048)
Batteries
(CR2032)
www.petsafe.net
2C (HDT11-11049)
Batteries
(CR2032)
2F (HDT11-11048)
Waterproof
Seal
7