Smith S103E Manual De Uso Y Cuidado página 4

Filling
IMPORTANT: Always make sure the pressure is
released from the tank before filling or servicing.
1. Pull up on the knob of the pressure release
valve until all the pressure is released from the
tank. (See Figure D.)
Pump Unlocking And Pressurizing
Shut-Off
1. Direct nozzle away from you and squeeze shut-off
lever to begin spraying.
2. This model does have a locking trigger.
OPERATING INSTRUCTIONS
Pump Clamp Tab
TO UNLOCK PUMP: Turn handle counterclockwise
until 4-prong clamp is loose, then rotate clamp
counterclockwise aligning the tabs with the slots
in the neck of the tank and remove the pump.
TO LOCK PUMP: Align clamp tabs with the slots in the
neck of the tank and lower the pump assembly, rotate
the 4-tab clamp clockwise to the stop position and
rotate the handle clockwise to tighten, seal and lock the
tank cover.
TO PRESSURIZE: Push down on the handle to depress
coil spring and turn handle 1/4 turn counterclockwise to
unlock handle. Pressurize the sprayer by pumping the
handle in a smooth up and down motion. Push down on
the handle to depress coil spring and turn handle 1/4 turn
clockwise, then allow handle to raise into lock position.
Figure D
Page 4