Bolster Attachment; Part Kits; Attachment; Seats - Allsteel Recharge Instrucciones De Instalación

Bolster Attachment

Failure to install product as instructed, use of hardware other than that which is provided, or failure to comply
with instructions can result in product failure, personal injury, or property damage.
Illustration 1a: Part Kits
Seating kit includes the following (see visuals below):
• Seat Structure
• Hardware Pack
• Screen & Bolster Assembly
Seat Structure
5/16-18 x 5" Bolt (QTY 6)
5/16 Lock Washer (QTY 6)
Illustration 1b: Bolster Attachment
Step 1: Gently set the screen and bolster assembly flat on the back of the screen.
Step 2: Flip the seat structure onto its back and carefully push it towards the bolster.
Step 3: Thread the 5/16-18 x 5" bolts (each with a washer and lock washer) through the seat structure and into the
corresponding bolster rivnuts. If bolts do not thread easily, ensure that rivnuts are fully engaged into seat slots.
Step 4: Before fully tightening bolts, adjust the bolster to align its center seam with the center seam of the seat.
Pages 2 of 5
W A R N I N G
5/16 Washer (QTY 6)
Before removing kits from packaging, clear a space for
all components either on carpet or on a clean protected
surface to ensure that units do not get damaged or dirty.
* C A U T I O N *
5/16 Washer
5/16 Lock Washer
5/16-18 x 5" Bolt
FRONT VIEW
Installation Packet
Screen & Bolster Assembly
(1 of 4 configurations)
3430383000