Allsteel Recharge Instrucciones De Instalación página 5

Ganging
Illustration 3b: Seat-to-Connector Ganging
Step 2: Align the connector with the side of the seat (ensuring that units are properly leveled).
Step 3: Install each #12-8 pan head screw into the bottom of the connector, ensure that the bracket is fully engaged
into seat bottom piece and units are tight against each other, then install either the #12 screws (for Straight
Connector) or the 5/16 bolts (for 120x2 and 120x3 Connectors) into seat.
NOTE: It is recommended to flip connector on its side to install all necessary
wood screws before attempting to gang with a seating unit.
Illustration 3c: Seat-to-Seat Ganging
Step 1: Locate the ganging slots on the underside of each seat (slot locations vary between models).
Step 2: Link each seat by locating each end of the ganging bracket into the corresponding slot.
Step 3: Fasten both sides of each ganging bracket to the wooden seat structure by tightening the 5/16-18 x 1.25"
bolts into each corresponding T-nut.
NOTE: Side-to-side ganging locations may
3430383000
differ from back-to-back locations.
Ganging
Bracket
#12-8 Screw
Installation Packet
5/16-18 x 1.25" Bolt
Page 5 of 5
Ganging
Bracket
#12-8
Screw