Allsteel Recharge Instrucciones De Instalación página 3

Electrical
Illustration 2a: Electrical - Seats
Step 1: Insert electrical module through cutout in seating unit.
Step 2: Attach module clamps and securely tighten against inside of unit, ensuring that module is square
with the seat.
Step 3: Feed the electrical conduit through the seat structure (up and over the center structure partition) to
reach the next connecting unit or closest infeed.
Step 4: If necessary, continue linking units together with H-Connectors and jumpers.
NOTE: Wire management brackets
are available to help suspend
and secure cabling.
Step 5: If necessary, mount any required state or city code hardwire boxes in a non-visible location. It is
recommended to attach these boxes to the center structure partition piece.
3430383000
Wire Management
Bracket
New York Hardwire Box
Module Clamps
Tighten securely against
inside of unit
Partition
Chicago Junction Box
Installation Packet
Electrical
Module
Electrical
Conduit
Module
Page 3 of 5