Connectors; Part Kits - Allsteel Recharge Instrucciones De Instalación

Electrical & Ganging
Illustration 2b: Electrical - Connectors
Step 1: Insert electrical modules into each rectangular cutout in connector.
Step 2: Connect an H-Connector to the end of each conduit and link them all together with a jumper between each one.
Step 3: Connect the infeed to one of the H-Connectors. Use the remaining open plugs to link other units together.
More units
Illustration 3a: Ganging Part Kits
5/16-18 x 1.25" Bolt
#12-8 Screw
Illustration 3b: Seat-to-Connector Ganging
Step 1: Break off one end of ganging bracket at break away line by bending it up and down.
Page 4 of 5
Jumper
(links 2 modules together)
Straight Connectors (MLML15C or MLMR15C)
are required to be ganged to a seating unit
NOTE: H-Connector outlets/inlets are universal,
Electrical Module
H-Connector
More units
* C A U T I O N *
Break Away Line
Installation Packet
so it does not matter which slot is used
for the module, jumper, or infeed. Each
H-Connector has the option to link three
outgoing pathways with one incoming
power source.
More units
Infeed links to only
one H-Connector
Ganging Brackets
Bend end up
and down to
break off
3430383000