Teka HSB Serie Manual De Instrucciones página 32

IMPORTANT
As a result of the high temperatures inside
the oven, the cooling process may vary de-
pending on the room temperature.
10. Once the oven has cooled down, the
symbol will turn off.
11. Open the oven door and wipe the inside
with a damp cloth, removing the ash from
the cleaning cycle. Hard-to-reach areas
in the oven will need to be cleaned with a
non-metallic fibre scourer.
12. Once the oven is clean, do not forget to
replace the supports and accessories.
13. The oven is now ready to be used.
IMPORTANT
If any incident is detected in the program-
ming or use of this function, consult the in-
stallation and maintenance guide included
with your oven.
POWER SUPPLY FAULT DURING PYROLY-
SIS PROCESS
If there is a power cut during the pyrolysis pro-
cess, when the power is restored the following
is displayed on the oven screen:
32
User's Guide
CANCELLING THE PYROLYTIC FUNCTION
Pyrolysis is an automatic function and there-
fore it can only be activated from the timer
programme. To cancel a pyrolysis in progress
it is necessary to reset the oven, following the
instructions below:
1. Set the control dial to the
The timer display will appear as follows
2. Depending on the internal temperature of the
oven, either of the two following situations
could arise:
a) Dangerous internal temperature: In this
case, the door will remain locked until the
temperature reaches safe levels.
b) Safe internal temperature: If the temper-
ature inside the oven is safe, the door will
be unlocked immediately.
3. Once the door has been unlocked and can
be opened, the time will show once again on
the timer display.
In this state, set the control dial in position
If the temperature of the oven is safe, it will au-
tomatically unblock.
However, if the oven temperature is not yet safe,
the oven will cool down and unlock automatical-
ly after one hour.
If the door has not unlocked after this time, dis-
connect the oven from the main power supply,
reconnect it and try to unlock it manually, follow-
ing the steps in the chapter "Manual door lock"
position.
.