Publicidad
Idiomas disponibles
Idiomas disponibles
6. Remove tail lamp Bezel. - Using a suitable flat bladed tool release the locking tabs and pull the tail lamp bezel from rear
bumper fascia.
7. Remove the Rear Fascia. - remove the rear wheelhouse panel bolts (Qty:4) 2 on each side labeled as # 1 in the picture below.
Remove Rear Bumper Fascia Bolt (Qty: 10) labeled as #2 on the picture below. Remove Rear Bumper Fascia Outer Support
Bracket Bolt (Qty: 4) labeled as #3, Rear Bumper Fascia Lower Bolts (Qty: 8) labeled as #4, Rear Bumper Fascia Upper Bolts
(Qty: 2) labeled as #5. Then with the aid of an assistant, carefully pull the rear fascia straight back to disengage the plastic clip
retainers located on the rear bumper fascia guide. Disconnect any electrical connectors.
8. Remove the fuel tank door. - Position the fuel tank filler door to the full open position. Using light outward sliding pressure on
the filler door, release the retainer on the fuel tank filler door from the hinge.
Corvetter Carbon Fiber Quarter Vents
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
84347360
IR 11SE17
PART NO.
DATE
11SE17
Initial Release - Scott Pouls
3
SHEET
REVISION
24
OF
AUTH
2641661
Publicidad
