Publicidad
Idiomas disponibles
Idiomas disponibles
21. Install the rear Wheel liners.
Install the rear wheelhouse liner (3) into position. Install the rear wheelhouse liner fasteners (1) and tighten to 9 Nm (80 lb in).
Install the rear wheelhouse liner fasteners (2) and tighten to 2.5 Nm (22 lb in).
Install the rear wheelhouse liner retainer (1) and tighten the fasteners (2) to 2.5 Nm (22 lb in).
Install the rear wheelhouse opening rear molding (2) and tighten the fastener (1) to 2.5 Nm (22 lb in).
22. Reattach the rear fascia. - using an assistant guide the fascia to the rear of the car. Before attaching make sure all electrical
connections are connected and line up the rear fascia clips with the guides on the car. Bringing the fascia straight in to the clips
make sure all clips engage and the fascia is secure to the car before letting go.
Tighten the Rear bumper fascia bolts (2) (Qty:10) to 2.5 Nm (22 lb in), then tighten the rear fascia outer support bracket bolts
(3) (Qty:4) to 7 Nm (62 lb in), then the lower fascia bolts (4) (Qty:8) to 7 Nm (62 lb in), next tighten the Upper Fascia bolts (5)
(Qty:2) to 7 Nm (62 lb in).
Corvetter Carbon Fiber Quarter Vents
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
84347360
IR 11SE17
PART NO.
DATE
11SE17
Initial Release - Scott Pouls
7
SHEET
REVISION
24
OF
AUTH
2641661
Publicidad
