How To Use - TOPDON Volcano2000Pro Manual Del Usuario

How To Use

Jump Start Your Vehicle Battery.
1. Connect the smart battery clamp CP010 to the jump starter, the jump starter state [OK]
LED will illuminate green light indicating ready to use, and [Fault] LED will illuminate red
light if there is some issue;
Connect the red clamp to the positive terminal (POS, P, +) of the battery; and connect the
2.
black clamp to the negative terminal (NEG, N,-) of the battery;
3. Start the vehicle;
When your vehicle is started, disconnect the clamps from the vehicle battery.
4.
10
Attention:
Digital Display
Under voltage, jump starter battery voltage is under 10V,
UV; showing -- -- --
please charge the jump starter; or when vehicle battery
is under 8V;
Over voltage, Vehicle battery level is higher than jump
OV; showing -- -- --
starter's;
Current back flow, V2000 Pro battery level too low,
CB; showing -- -- --
please charge the jump starter;
Over temperature, turn off V2000 Pro wait for it cool-
OT; showing -- -- --
ing down;
Short circuit, clear battery posts and clamps, check
SC; showing -- -- --
the connection in between;
Exceed connection time/overload, clear battery posts
No Icon; showing -- -- --
and clamps, check the connection in between.
Tool Status
11