Battery Charging - TOPDON Volcano2000Pro Manual Del Usuario

Battery Charging

Charge this product via the USB type-C input from the wall socket or other 5V output
devices.
When this product is being charged, its LCD will display "Charging" message. When
it's fully charged, the LCD will display a "100%" message.
Please charge this product for at least 8 hours before the first use.
5V USB Charger Rating
1A
Time 12hr
14
2A 3A
6hr
4hr
Important
The battery jump procedure is only for use on vehicles with 12 volt batteries.
Use only the smart battery clamps supplied with this product.
Only jump start the vehicle when capacity is at least 50%.
Better not get the two battery clamps contacted together.
If the engine does not start, disconnect this product from the vehicle battery, and wait for
at least 20 seconds before reconnecting. Maximum three attempts are allowed in 2 minutes.
Once the vehicle engine is successfully started, disconnect the clamps within
30 seconds.
DO NOT use this product if any cable, clamp or cord is damaged.
DO NOT put the product under the direct sunlight or hot areas.
DO NOT disassemble the equipment.
DO NOT use chemicals or detergents to clean the product.
DO NOT place the products in high temperature environment for a long time.
Check the charge level of the device every four months, and charge the device if needed.
15