Cleaning & Servicing; Frost Protection - Delabie TEMPOSOFT Manual De Instrucciones

Dripping or a constant trickle (fig. K)
• Clean the seat r or replace if damaged.
• Remember to replace the spring p.
Beware: do not grease the inside of the mechanism.
CLEANING & SERVICING
Cleaning chrome
• Do not use abrasive, chlorine or any other acid-based
cleaning products. Clean with hot, soapy water and a clean
cloth or sponge. Dry using a clean, dry cloth.

Frost protection

• Drain the pipes and operate the mixer several times
to drain any remaining water.
REMEMBER
• Our mixers/taps and valves must be installed
by professional installers in accordance with current
regulations and recommendations in your country,
and the specifications of the fluid engineer.
• Sizing the pipes correctly will avoid problems of water
hammer and loss of pressure/flow rate. (See the calculation
table in the brochure or on line at www.delabie.com).
• Protect the installation with filters, water-hammer
absorbers or pressure reducers to reduce the frequency
of maintenance. (Recommended dynamic pressure: 1-5 bar,
2 bar for siphon-action urinals) to facilitate maintenance.
• Install stopcocks close to the mixer to facilitate maintenance.
• The pipework, stopcocks, valves and all sanitary ware must
be checked regularly.
For UK market only: Tel. 01491 821 821 email: technical@delabie.co.uk
For all other markets: Tel. +33 (0)3 22 60 22 74 email: sav@delabie.fr
The most recent version of this installation guide is available on: www.delabie.com
After Sales Care and Technical Support: