Klarstein 10033771 Manual De Instrucciones página 17

Burst of Steam
This function will be able to provide more steam to remove stubborn creases.
1. Set the thermostat dial button to MAX until the indicator light goes off.
2. Release the steam by pressing the steam button.
3. Wait for several minutes and let the steam penetrate through the fabric, and then
release more steam through pressing this buttons again.
Notes
• There should be 3-5 seconds rest between two times of pressing Steam Button in
order to obtain the best steaming result.
• Fill the water to the Max position before using this function.
• In order to prevent the water leaking from soleplate, please do not press the steam
button continuously with more than 5 seconds.
Spraying Methods:
1. Fill the water in the iron as per water-filling methods.
2. Press water spray button.
Note: No matter what steam ironing or dry ironing is, Spray will always be available in
any case.
Self-cleaning
In order to remove scale and impurities, apply self-clean system once every month at
least.
1. Fill half of the box with box. Set the steam knob to No Steam position.
2. Plug in the iron to the socket. Set the thermostat knob dial to Max.
3. When the pilot light goes off, i.e. the steam iron has been in its presetting
temperature.
4. Unplug the iron, and hold the appliance horizontally over a sink.
5. Set the steam knob to position "Self-Clean", boiling water and steam will come out
from the soleplate, shake the iron slightly in order to wash out impurities & scale.
6. Set the steam knob to position O when no water in the box.
7. Stand the iron on its end and plug the appliance in the socket, heat up the iron
again.
8. Move the iron over a piece of clean cotton cloth, and the remaining water in the
iron will evaporate from the soleplate.
Anti Calc
With a small filter built-in,which can make hard water soft, thus preventing any calc or
flake accumulated on the surface of soleplate,this features can prolong the life of the
iron for long use.
Anti Drip
With a bimetal assembled inside the iron, which can close the steam when the iron
soleplate becomes very low, so water leakage will never happen with this features.
Auto Shut-Off, Auto Turn-On
EN
17