Maytag M1200 Manual Del Usario página 16

7. TROUBLESHOOTING
IF YOU COME ACROSS ANY OF THESE PROBLEMS HERE ARE SOME POSSIBLE SOLUTIONS.
IF PROBLEM IS NOT LISTED OR SOLUTION FAILS TO SOLVE PROBLEM, CONTACT
STOREBOUND DIRECTLY AT 1-800-898-6970 OR
7.1 The iron is plugged in, but the soleplate of the
iron isn't heating up.
• Check that the power plug is properly inserted or try
plugging the iron into a different outlet.
• Temperature is set too low. Set the temperature control
to a higher temperature. See Figure R.
• Automatic shut-off is active. Try moving your iron.
7.2 None or too little steam is being emitted.
• Check to see if the steam switch isn't on the dry setting.
Adjust setting on switch. See Figure S.
• There might not be enough water in the Removable
Water Tank. Try filling the Removable Water Tank.
• There is an anti-drip feature that could be enacted. Make
sure that the iron has reached the correct temperature.
7.3 Brown streaks come through the holes in the soleplate and stain the fabric.
• Residue could have built up in the steam chamber or on
the soleplate. Try using the Self-Cleaning feature to
remove the residue in the iron. See Figure T.
• Using an Iron Descaling agent can sometimes cause this.
There is no need to use one; the self-cleaning feature will
rescale the iron without it.
• Fabric fibers can often build up in the holes of the
soleplate. Try cleaning the soleplate with a
non-metallic sponge or vacuuming out the holes.
14
info@storebound.com
Figure R
Figure S
Figure T