inda AV474A Instrucciones Originales página 2

GB
ORIGIN L INSTRUCTIONS
C UTION:
For additional protection, the installation of a residual current device (RCD)
having a rated residual operating current not exceeding 30m is advisable
in the electrical circuit supplying the bathroom. sk your installer for advice.
Make sure the unit is perfectly dry before using it.
W RNING:
Do not use this appliance near bathtubs, showers,
basins or other vessels containing water.
This appliance can be used by children from 8 years of age and over, and by
persons with limited physical, sensory or mental abilities or who lack the
relevant experience and knowledge, if they are suitably supervised or have
been educated to use the appliance safely and made aware of the associated
risks.
Do not allow children to play with the appliance.
Children must not perform cleaning and maintenance procedures unless
supervised.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or a similarly qualified person in order to avoid a hazard.
Do not use your unit if it is not working properly. Do not try to repair this
electrical unit yourself, rather contact an authorized technician.
Designation of the appliance (see technical product specifications)
W LL-MOUNTED H ND DRYER FOR COMMERCI L USE
The -weighted sound pressure level emitted is below 70 dB( ).
INT LL TION:
Only install the appliance in zone 3 (see figure pag. 21).
1 Remove the "T" bracket on the back of the equipment, by unscrewing
(Fig.1).
screw
2 Use the bracket as a template for marking the positions of the holes to be
drilled for fixing (Fig. 2).
Drill holes in the wall using a 6 mm Ø drill bit.
3 Fix the "T" bracket using the screws and anchors provided (Fig. 3).
4 Hang the equipment on the bracket and fix it at the bottom using
2