Publicidad
Idiomas disponibles
Idiomas disponibles
6
6. Loosen screws used to hold the middle
hinge and remove middle hinge. Then
remove the lower door.
7. Place the lower door on a smooth
surface facing upwards. Change the
handle to the right side by following step
5 described in page 7. Remove the self-
tapping screws, detach the stop block
and door holder.
Turn the door holder 180° and then
install it and the spare stop block on
the opposite side with the self-tapping
screws.
8. Place the screw hole covers on the
middle plate on the opposite side.
9. Place the refrigerator fl at on the fl oor,
remove adjustable feet and self-tapping
screws. Remove the front foot fi xed
bracket and lower hinge.
10. Unscrew the lower hinge, change it
to the opposite side and reattach and
mount washer.
11. Change lower hinge part to the left
side and front foot fi xed board to the
right side, then fasten with self-tapping
screws. Finally install adjustable feet.
12. Install the lower door by sliding it in a
downward motion and align the lower
hole site on the bottom of the door and
the upper hinge site. Turn the middle
hinge piece 180°, change the washer
on the axis to the upper side, adjust the
middle hinge to the appropriate position
and then reinstall it.
Note: The washer may
stick to lower door.
Washer
Washer
Note: The washer may
stick to lower door.
Publicidad
