Uline H-2634 Guia De Inicio Rapido página 4

1. Liquids should begin flowing on second or third
upstroke. If slight leakage should occur, simply
tighten packing nut on top of pump.
NOTE: Tighten only enough to prevent leakage.
Excessive tightening will damage the packing
nut and cause more leakage.
2. When finished pumping, place cap on end spout to
prevent dripping.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • CANADA • MEXICO
PAGE 4 OF 12
ASSEMBLY CONTINUED
Figure 5
20
15
21
OPERATION
1-800-295-5510
uline.com
PAIL ADAPTER INSTALLATION
NOTE: This adapter is designed to fit senior
(metal ring) flexspout closures.
1. Screw adapter (15) on male threads (20) at bottom
of pump. Tightly secure adapter. (See Figure 5)
2. Remove pail cap on flexspout. Collapse flexspout
into pail.
3. Insert tube extension into opening, then snap
adapter onto metal ring (21). (See Figure 5)
4. To remove pump with adapter from pail, pull towards
side of pail and snap off making sure to hold pail
down.
3. If pump is removed from drum, rinse thoroughly in
liquid that is compatible with both the pump and
fluid. For questions about chemical compatibility,
contact your chemical supplier.
MAINTENANCE
• Normal maintenance is not required. If pump leaks
at the top, replace packing nut.
0715 IH-2634