Outdoor Leisure TD101A Instrucciones De Ensamble página 3

4. Install electronic ignitor through control panel. Screw retainer ring
and ignitor cap on from outside panel. Attach ignitor ground wire
to the left hand terminal of ignitor.
Insert battery into electronic ignitor with positive terminal facing
outward.
Screw ignitor cap onto electronic ignitor.
5. Remove wire tie and packing material from regulator located
underneath burner support plate.
121451-01A
6. Position burner support plate on top of panels while carefully
inserting control valve through hole in control panel.
7. Attach control valve bracket to table control panel with 2 screws
(C). Attach control knob to control valve from outside of heater.
8. Attach burner support plate to panels with 4 screws (C).
9. Attach emitter screens to emitter brackets with 4 screws (C).
www.desatech.com 3