HEINE ML4 Manual De Instrucciones página 8

Fitting the headband rheostat
You can fit the headband rheostat (1) either on the left or the right side of the head-
band (see Fig. 3). The headband rheostat (1) can then be used for stepless adjustment
of the brightness.
It is recommended that the mPack rheostat is set to „0".
1
1
Abb. 3 Fitting the headband rheostat
Operation
To set up the ML4 LED with mPack or EN50, connect the short cord from the bright-
ness control with the connecting cord mPack UNPLUGGED/Cinch and fix this to the
back part of the headband (Fig. 4). Connect the instrument to the Cinch-socket of the
mPack or EN 50. The rheostat (1) (Fig. 3) is used to adjust the brightness and to turn
the device on and off.
Fig. 4
To use the ML4 LED with the mPack UNPLUGGED first remove the rear cover of the
headband (Fig. 5).
Fig. 5
8/52
MED 113192 2018-03-21