Setting Trimmer Adjustment Procedure - A.E.B. 628127000 Manual Instrucciones De Montaje

SETTING TRIMMER ADJUSTMENT PROCEDURE

In order to calibrate the regulation trimmer of the emulator, it is
necessary to follow this simple operative procedure:
1) Turning on the engine of the vehicle and connecting the OBD
TESTER to the OBD plug of the car.
2) Connecting the EMULATOR to the pressure sensor of the car.
3) On the OBD TESTER, selecting the parameter "FUEL PRESSION"
and visualizing the pressure of the work of the fuel with the engine
at idle during the PETROL mode running.
4) Passing to GAS and verifing if there is a variation of the pressure
of the work of the fuel during the GAS mode running.
5) In case the pressure of work of the fuel has a variation respecting
the PETROL mode running, rotating the trimmer of the emulator
in clockwise/counter clockwise direction until the alignment of the
value of the fuel pressure.
6) Changing again the vehicle to PETROL mode and repeat the 5th
point of the procedure in order to refine the gauging.
The warranty certificate of the product is available on
AEB web site (www.aeb.it) in the section products/
emulators/628127000.
9 - 16
Principle functioning
BACK VIEW OF THE EMULATOR
English
190100548 Rev. 270411-0