Publicidad
Step 12
Carefully stand your unit upright.
å
1. Insert the remaining PIVOT HINGE (X) into the
å
WASHER (Y) and into the BOTTOM(I).
2. Insert the PIVOT HINGE, which is fastened to the
å
DOOR (N), into the hole in the SHELF (HH3). You will
need to tilt your DOOR slightly.
3. Now, tip the DOOR in and fasten the free HINGE to the
å
DOOR. Use a BROWN 7/16" LARGE HEAD SCREW (HH)
Fasten the HANDLE (Z) to the DOOR (N). Use two BLACK
å
7/8" FLAT HEAD SCREWS (FF).
NOTE: To make adjustments to the DOOR, loosen the
å
SCREW in the HINGE, make needed adjustments, and
tighten the SCREW.
Page 16
BROWN 7/16" LARGE HEAD SCREW
X
st
1
HH3
Y
nd
2
I
rd
3
408726
HH
(1 used for the PIVOT HINGE)
Z
N
31S
BLACK 7/8" FLAT HEAD SCREW
(2 used for the HANDLE)
www.sauder.com/services
FF
Publicidad
