Component Information - Denso first time fit Instrucciones De Extracción E Instalación

Registration
After installation, register the new ID numbers to the vehicle through the OBD II port, set
alarm air pressure and test the motor vehicle TPMS using procedures described in the original
manufacturer's service guide. Adjust alarm air pressure as needed.
If the system fails to operate properly, check all the installation procedures to ensure proper
installation and retest.
 WARNING: Failure to properly install and ensure that the TPMS is working properly can
result in collision, severe injury, or death.
NOTE: TPMS works using an RF Frequency. During registration it is best to maintain a distance
from electric noise to insure proper registration.

Component Information

Grommet: Replace with a new grommet every time the TPMS sensor is removed or the tire is
replaced. Do this even if there is no damage such as a crack or break.
Valve Cap: Ensure to attach the valve cap. Use DENSO parts.
Valve Core: Only use DENSO Ni-plated valve cores.
Nut and Washer: Replace nut and washer (when provided) with new DENSO parts when TPMS
sensor is removed or tire is changed. Do not reuse nut and washer once tightened.
Troubleshooting
1. If the TPMS telltale
diagnosis:
A. Turn the vehicle ignition to the OFF position for at least 30 seconds.
B. Start the vehicle and pay attention to the telltale. Is the telltale flashing or steady
during the first 20 seconds of starting the vehicle?
2. Telltale not flashing (under inflation):
A. One of your tires is under inflated. Check all tires, including the spare, to confirm
the correct pressure.
B. Keep in mind that cold temperatures can lead to low pressure in a tire.
C. Make sure there is a good seal around the rim valve hole. Use soapy water to
check for a leak around the seal area.
D. Refer to the original manufacturer's service guide to confirm any requirement to set
the threshold for warning.
3. Telltale is flashing (improper communication from sensor to receiver):
A. Did you register the new ID numbers to the vehicle through the OBD II port?
B. Confirm the part number is the correct part for the specific make, model, and
model year vehicle.
C. Confirm transmission from TPMS sensor using a trigger tool manufactured to
interface with the specific part number for that make and model.
D. Communicate with the Point of Sale for further information.
4
remains illuminated in your vehicle, perform the following