Ingersoll Rand X8I Manual De Utilización página 39

1 1
2 2
3 3
4 4
Control - Equal Hours Run Mode
C01 – 01 to C01 – 'n' Run Hours'
'n' = number of compressors in the system. 8 is the
maximum number of compressors for the X8I
This parameter is set to match the running hours of
each compressor. Record of detected 'running' hours for
each compressor. The run hours value can be manually
adjusted, at any time, to match the running hours meter/
display value of each compressor. The default setting for
this parameter is 0 hours. The values for this parameter
are:
"0 to x" where x = the actual run hours for the
compressor
1 1
2 2
3 3
4 4
C02 – 01 to C02 – 'n' Compressor Maintenance
'n' = number of compressors in the system. 8 is the
maximum number of compressors for the X8I
This parameter is set for a compressor(s) that is
unavailable for use for a prelonged period for time due to
maintenance or repair. The compressor will not be utilised
under any circumtances; any Alarm (Warning) or Trip
(shutdown) fault will be ignored. The default setting
for this parameter is . (Represents the compressor is
available) The values for this parameter are:
= Remove compressor from operation
= Compressor can be utilised
39