INTERVOX ZEN Manual Del Propietário página 25

Siren, Isolation, Reading of log, Tele-configuration
The "Test" menu is used to test the operation of:
detection loops 1 to 8 (bottom line), the "SOS" loop and the "Self-protection" loop
(right-hand side of top line).
detection loops 9 to 16 if the control unit is equipped with the extension option,
the 32 radio channels if the control unit comprises the radio option.
When this menu is entered, all the "_" are in the bottom position.
When the system is triggered, the "_" is replaced by an "X" and the keypad outputs a
beep,
When the system returns to stand-by mode, the "X" is replaced by a "-" and the keypad
outputs a beep,
The "OK" key enables the sirens to be activated for 2 seconds.
The system displays the latest event stored with the date and time.
The ▲ and ▼ keys enable the previous or next events to be displayed.
The system specifies the event and indicates the following at the end of the line:
"X" loop in alarm mode and "-" return to stand-by mode,
"T" event not transmitted due to traffic congestion,
"F" when the user implements a forced activation of a surveillance mode,
"P" low battery on a sensor and "p" battery OK,
"A" self-protection fault, "S" supervision fault.
Example 1: Alarm on loop 2, on 22 August 2001 at 10:25.
Example 2: Cyclic test not transmitted, on 22 August 2001 at 11:40.
Example 3: Deactivation of Sector 1 surveillance by the third code, on 23 August 2001 at
7:25.
The various parameters of the control unit (time delays, telephone numbers, etc.) can be
remotely modified from the call centre or from the maintenance centre.
To access this function, the user must use the keypad to enter the telephone number of
the tele-configuration centre, which will carry out the required changes.
At the beginning of the telephone number, the user must press the "Menu" key:
Example: to enter the telephone number 0155 232 525, type "Menu and 0155232525".
The display indicates: "P0155232525". The user makes the call by pressing the "OK" key.
Following a persistent fault on a sensor, the user may need to isolate a loop or a radio
channel (radio option).
The ◄ and ► keys can be used to select the loop or the channel that the user wishes to
isolate.
The digit "1" activates the isolation, the digit "0" deactivates the isolation.
The "Partial" key (2) is used to confirm the isolation.