D
I
ESKTOP
1. Plug the coiled cord into the handset. Plug the other end into the jack on the side of the base.
2. Place the handset in the base.
3. Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE for pulse (rotary)
service. If you don't know which type of service you have, check with the phone company.
4. Plug the long telephone line cord into the LINE jack on the back of the phone. Plug the
other end into a wall jack.
5. Connect the small end of the power supply into the POWER 9V AC jack on the back of the
answerer. Plug the other end into an AC power outlet. The unit counts up, beeps 3 times,
and is ready for setup or to answer calls with the default greeting and settings.
5
CAUTION: Only use the Thomson 5-2434A
power supply that was packed with this unit.
Using other power supplies may damage the
unit.
NSTALLATION
4
3
2
INSTALLATION INFORMATION
• Never install telephone wiring during
a lightning storm.
• Never touch uninsulated telephone
wires or terminals, unless the
telephone line has been discon-
nected at the network interface.
• Use caution when installing or
modifying telephone lines.
1
5