Using The Electric Pasta Cooker - Comcater NPC74G Serie Instrucciones Para Instalación, Uso Y Mantenimiento

BURNER IGNITION AND EXTINCTION
The gas valve control knob has the following positions
Off
Pilot ignition
Maximum flame
Pilot ignition
Press and turn the knob to position "
• Press the knob fully down to activate the electronic ignition
and light the pilot burner.
• Hold the knob down for about 20 seconds before releasing it.
If the pilot flame goes out, repeat the operation.
• The pilot flame can be seen through the peep hole on the
control panel.
Main burner ignition
Press and turn the knob from position "
Switching off
To switch the main burner off, press and turn the knob to posi-
tion " ".
To switch off the pilot flame, press and turn the knob to position
" ".
SWITCHING ON AND OFF
The energy regulator control knob has the following positions :
Off
1 Minimum power - Holding
2..4 Intermediate power - Cooking
5 Maximum power
Switching on
Turn the energy regulator knob to any position between "1" and
"5".
• The yellow indicator light switches on.
Switching off
Turn the energy regulator knob to position "
• The yellow indicator light switches off.
COOKING
• Fill the well.
• Turn the knob to position "2".
• Light the burners.
• Adjust the heating according to your cooking requirements.
When the chosen cooking position is other than "5", heating
is intermittent. It switches on and off automatically. The boiling
intensity of the water may vary visibly, but this has no effect on
cooking. When the heating switches off, the yellow indicator
light switches off too.
AT THE END OF SERVICE
• Switch the heating off.
• Switch the burners off
• Empty the well completely.
6
• Turn the knob to position "0".

13 USING THE ELECTRIC PASTA COOKER

REMINDERS FOR USE
• The appliance is designed for boiling pasta, rice, vegetables
• The appliance is fitted with a pressure switch which stops
".
• While the pasta cooker is on, the water level must be main-
• Use very fine grained salt, adding it to the tank when the wa-
• At the end of each day, clean the well thoroughly in order to
FILLING AND EMPTYING THE WELL
" to position " ".
Filling
The control knob has the following positions:
0 Off
1 Water filling - rapid filling
2 Halt water filling - Activate heating
3 Water filling - slow filling
• Turn handle " H " of the drain valve anti-clockwise. The drain
• Turn the knob to position " 1". Use position "3" to top up water
• Fill the well until the water is level with or above the minimum
• To halt filling, turn the knob to position "0" or "2".
Emptying
Turn the handle " H " of the drain valve clockwise. The drain
is completely open when the handle is in the vertical position.
SWITCHING ON AND OFF
The energy regulator control knob has the following positions :
".
1
2..4 Intermediate power - Cooking
5
Switching on
Turn the energy regulator knob to any position between "1" and
"5".
• The yellow indicator light switches on.
Switching off
Turn the energy regulator knob to position "
• The yellow indicator light switches off.
and similar foodstuffs in water.
activation of heating in the event the water in the well falls
below the safety level ( approx. 12 cm ). To restore heating
in the event the pressure switch is tripped, top up the water
level to the minimum mark visible on the rear wall of the well.
tained level with or above the minimum level indicated on the
rear wall of the well.
ter is boiling. Do not use coarse-grained rock salt in the tank.
prevent the formation of corrosive deposits.
is completely closed only when the handle is in the horizontal
position.
used during cooking. Water fills from tap located under the
draining board.
level ( bottom mark ) indicated on the rear wall of the well.
Off
Minimum power - Holding
Maximum power
".