Safety Instructions - Sony Artisan GDM-C520K Guia De Inicio Rapido

Ocultar thumbs Ver también para Artisan GDM-C520K:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Quick Start Guide

Safety Instructions

Observe the following safety instructions when connecting and using your display:
Be sure that your display is electrically rated to operate with the AC power available in your location.
Locate your display near an easily accessible electrical outlet.
Place your display on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or touched with a sharp or
abrasive implement.
Place your display in a cool location with low humidity and a minimum of dust.
Do not use your display if the power cable has been damaged. Do not allow anything to rest on the power cable, and keep the cable away
from where people can trip over it.
Do not insert anything metallic into the display openings. Doing so may cause electric shock.
To avoid electric shock, do not touch the inside of the display. Only a qualified technician should open the display's case.
Hold the plug, not the cable, when disconnecting the display from an electrical outlet.
Openings in the display cabinet are provided for ventilation. To prevent overheating, these openings should not be blocked or covered.
Also, avoid using the display on a bed, sofa, rug, or other soft surface. Doing so may block the ventilation openings on the bottom of the
cabinet. If you put the display in a bookcase or other enclosed space, be sure to provide adequate ventilation.
Do not expose the display to rain or use it near water. If the display accidentally gets wet, unplug it and contact an authorized dealer
immediately. You can clean the exterior of the display with a damp cloth when necessary, but be sure to unplug the display first.
If your display does not operate normally in particular, if there are any unusual sounds or smells coming from it unplug the display
immediately and contact an authorized dealer or service center.
Connecting your Artisan
1
Note: Before connecting your GDM-C520 display, turn off your computer and unplug its power cable.
1
Connect the GDM-C520 display's power cord to the display, and plug the cord into a nearby outlet.
Press the power button on the front of the display to verify that the display powers up; then, press the power button again to power down
the display before moving to Step 2.
2
Connect the HD15 connector located on the Artisan
3
Connect and secure the USB connector on the other end of the Artisan
4
Connect the other HD15 connector to the HD15 port on the back of your computer.
5
Plug your computer's power cable back into an electrical outlet.
Turn on your display and computer. If the display does not show an image, refer to the troubleshooting section of this guide.
Color Reference Display to your Computer
TM
Rear of Display
2
2
1
AC IN
to HD15
port
TM
Signal Cable to an HD15 port on the rear of the display.
Rear of Computer
3
to USB port
to HD15 port
TM
Artisan
Signal
4
Cable
(Supplied)
Signal Cable to a USB port on the back of your computer.
TM
US
5
3

Publicidad

Tabla de contenido
loading

Tabla de contenido