Connector Panel - Sony JJTRON ADN-8118 Manual De Instrucciones

Location and Function of Parts and Controls

Connector Panel

INPUT A
R
G
1
B
HD/
COMP
SYNC
VD
31K RGB
IN
2
CONTROL S
OUT
IN
3
REMOTE
OUT
4
ADDRESS
ON
5
TERMINATE
OFF
8
(GB)
1 INPUT A connectors
R, G, B connectors (BNC type): Input the 31.5k
analog RGB signal. Connect to the 31.5k RGB
output of a computer or video equipment.
HD/COMP connector (BNC type): Inputs the H sync
signal or composite sync signal. Connect to the H
sync or composite sync output of a computer or
video equipment.
VD connector (BNC type): Inputs the V sync signal.
Connect to the V sync output of a computer or
video equipment.
6
Note
When the RGB signal with Sync on Green signal is
input, do not connect anything to the HD/COMP
connector.
2 CONTROL S IN/OUT jacks (minijack)
IN jack: Connects to the CONTROL S OUT jack of
the supplied Remote Commander with the supplied
remote control cable. You can also use the stereo
cable with stereo minijacks.
OUT jack: Connects to the CONTROL S IN jack of
other Sony equipment.
3 REMOTE IN/OUT connectors (D-sub 9 pin)
Use when connecting a computer via the RS-422
interface or connecting multiple units.
4 ADDRESS switch
Normally, set to the "0" position.
Set this switch when connecting multiple units.
For details, see page 16 (GB).
5 TERMINATE ON/OFF switch
Normally, set to the OFF position.
Set this switch when the RS-422 interface is used.
6 INPUT B board attachment part
Attach the BKJ-100 JJTRON Accessory Board (not
supplied).