Remote Control Operation - Sony JJTRON ADN-8118 Manual De Instrucciones

Location and Function of Parts and Controls

Remote Control Operation

The supplied Remote Commander can be used as a
wireless remote control if the RM-PJ10 remote control
receiver is used. However, it is recommended to
connect the unit to the supplied Remote Commander
with the supplied remote control cable in order to
control the unit more effectively.
Battery instllation
1
Push to open the lid.
2
Install the three R6 (size AA) batteries (supplied)
with the correct polarity.
Be sure to install the
battery from the # side.
3
Replace the lid.
12
(GB)
Notes on batteries
• Be careful that the battery orientation is correct when
inserting batteries.
• Do not mix old battery with new one, or different
types of batteries.
• If you do not intend to use the Remote Commander
for a long time, remove the batteries to avoid damage
from battery leakage. If a battery has leaked, remove
the batteries, wipe the battery compartment dry and
replace the batteries with new ones.
Notes on wireless remote control operation
• This unit is not equipped with the remote control
detector. For wireless operation, use the RM-PJ10
remote control receiver (not supplied).
• The operation range is limited. The shorter the
distance between the Remote Commander and the
unit, the wider the angle within which the Remote
Commander can control the unit.
Connecting the Remote Commander to
the unit
Left side
view
CONTROL S
Remote Commander
CONTROL S OUT
Remote control cable (supplied)
CONTROL S IN
IN
OUT