Style selections 1211VA-24-242 Manual De Instrucciones página 6

INSTALLATION INSTRUCTIONS
4. Clean bottom surface of sink (D). Following
silicone sealant's manufacturer directions, apply
a uniform bead of silicone sealant (not included)
around bottom outer ring of sink (D). Lower sink
(D) onto vanity top. Align sink's bottom drain
hole with inner hole of vanity top.
Note: Make sure sink (D) is completely dry
before applying sealant.
5. To remove drawer preassembled in vanity (A),
fully extend drawer. Locate plastic levers on
metal glide tracks at left and right sides of
drawer box and push on plastic levers on both
sides at the same time to disengage drawer
box from the glides. Gently lift the drawer
up to remove it from vanity (A).
1007VA-24-210-2
4
1026VM-30-242-1
5
6
1
D
2
A
A