Chaparral 544W Instrucciones Para Armar página 6

FIG. 6
6. Install the second Shelf (F) sliding it over and down onto the Rafix Bolts (N). Make sure
the Rafix Cams (M) are pointing down. Also, check that the back of the Shelf (F) is flush to
the back of the unit. If not, the shelf is in backwards. Rotate shelf 180 degrees and reinstall
onto Rafix Bolts (N). Tighten Rafix Cams (M) once the Shelf (F) is correctly positioned.
R
x 14
S
x 4
FIG. 7A
7. With the unit laying face down on a protective surface, measure from top left to bottom right
( ) and from bottom left to top right (
If the line
equal. If line
Attach Back (G) to the unit using Screw (R) in pre-drilled holes in the Back. Make sure the
back is centered side to side and about 1/8" from the top edge. Hammer Tack Glides (S)
into bottom corners of the unit. See FIGURE 7B.
Page 6 – 544W
is longer, tap bottom of Left Side Assembly (A) until measurements are
is longer, tap bottom of Right Side Assembly (D). See FIGURE 7A.
N
S
S
S
S
). Measurements should be equal.
M
M
N
N
R
R
R
R
FIG. 7B