Yakima HullyRollers Manual De Instrucciones página 2

do you have - square - round - or FaCTory Crossbars?
SQUARE BARS ONLY
Loosen the tabs in the
SQUARE
SnapArounds by bending
them repeatedly.
(SQUARE continued)
Attach SnapArounds
to REAR crossbar in
ROUND
opposite direction as
shown (2 per roller).
Position roller brake
tabs outboard.
Insert bolts
from above,
2 per roller.
Attach four MightyMounts
to the REAR crossbar
FACTORY
(2 per roller).
BARS
If your MightyMounts require
bar caps, install them now.
Position roller brake
tabs outboard.
Insert bolts
from above,
2 per roller.
UNIVERSAL
MIGHTYMOUNT
#03590
1033424C-2/15
BRake taB
BRake taB
Follow the Universal MightyMount
instructions and refer to this instruction for
correct installation.
Remove the
tabs with
scissors or
pliers.
15" / 38cm
Attach hex
keys and
tighten
COMPLETELY.
15" / 38cm
Use hex
wrench
to tighten
COMPLETELY.
ROLLER DISTANCE:
15"(38 cm) is an average
distance and will need
to be adjusted to your
boat's hull.
ROLLER DISTANCE:
15"(38 cm) is an average
distance and will need
to be adjusted to your
boat's hull.