Assembly - Close-To-Ceiling Mount
1
Preparing for mounting
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (II) located in the "L shaped"
slots.
□
Remove and save the two canopy screws (HH) in the round
holes. This will enable you to remove the mounting bracket
(A).
□
Remove the decorative canopy bottom cover (J) from the
canopy (C) by pressing the three studs.
A
HH
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to an outlet box marked
"Acceptable for fan support of 35 lbs. (15.9 kg) or less,"
and use the screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (LL).
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws (LL)
provided with the outlet box. If necessary, use leveling washers
(not included) between the slide-on mounting bracket (A) and
the outlet box. The flat side of the slide-on mounting bracket (A)
should face toward the outlet box, as shown.
□
Securely tighten the two mounting screws (LL).
2
Routing the wires
□
Remove three of the six screws and lock washers (KK) (every
other one) securing the motor collar (K) to the top of the fan-
motor assembly (D).
□
Route the wires exiting the top of the fan-motor assembly (D)
through the rubber gasket (EE) aligning the holes in the rubber
gasket (EE) with the three screws holes in the fan-motor
assembly( E), then through the canopy (C) (make sure the slot
openings are on top).
□
Place the canopy (C) over the collar at the top of the fan-motor
assembly (D), aligning the mounting holes with the holes in
the motor and fasten using the three screws and lock-washers
(KK) removed previously. Tighten the mounting screws
II
securely.
C
J
LL
8
KK
KK
C
EE
K
D
LL
A