Schön 67522-5201 Guía De Uso Y Cuidado página 5

Installation (continued)
3
Attaching the mixer to the
standpipe
NOTE: Do not to reverse the cold and hot supply.
□
Attach the mixer (C) to the standpipe (D), make
sure the prongs (1) on the standpipe (D) insert
into the hole (2) of the mixer (C).
□
Install the set screw (B) and tighten into the
standpipe (D) with hex wrench.
Front
1
Cold inlet
supply line
2
C
B
D
Hot inlet
supply line
4
Securing the standpipe
□
Locate the assembly on the desired location with
the exible tails (1) through the prepared hole
and then holding the escutcheon (E), secure the
standpipe (D).
□
If mounting into wooden oor, secure the
standpipe (D) using screws (F) only (wall plugs
are not needed). If mounting into solid oor,
mark the position of holes rst and then secure
the standpipe (D) using anchors (G) and screws
(F). Where requried ensure correct anchors for
your oor type are used.
1
5
Please contact (800) 880-8164 for further assistance.
D
F
G
1
www.schonsimplymodern.com
E