Dockin D Fine+ Manual De Instrucciones página 24

1. Premere il pulsante Play/Pause per 3 secondi per annullare la
connessione Bluetooth corrente.
2. Premere e tenere premuti i pulsanti +/-, quindi premere il tasto
. Questo cancellerà i dispositivi Bluetooth memorizzati e an-
che la connessione di accoppiamento stereo.
3. Quando la memoria Bluetooth viene cancellata, è necessario
ricollegare i dispositivi di riproduzione dopo questa procedura.
POSIZIONE DEGLI SPEAKER
2 Passive radiators
Left high
frequency driver
Domande? Problemi?
info@dockin.de
DOCKIN è un marchio di
Ströer Products GmbH | Torstr. 49 | 10119 Berlin
46
Right high
frequency driver
2 Low frequency driver
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interfe-
rence received, including interference that may cause undesired
operation.
FCC
Changes or modifications not expressly approved by the party re-
sponsible for compliance could void the user's authority to operate
the equipment.
This equipment has been tested and found to comply with the li-
mits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, the-
re is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
47